How To Frame A Corner

Whether interior or exterior, corners are a multitasking part of the wall. They form the connection between two right- (and sometimes oblique-) angled walls; they help support the structure above and provide sheer strength for exterior walls. They also offer nailing surfaces or backing, for drywall, exterior sheathing, and trim boards.

Corner Framing Methods

Traditional framing (3- or 4-stud corner)

In traditional framing, the corner was made from three or four studs and blocking made from scrap 2x lumber. (Fig.1) As energy and material costs increased, it became apparent that this method used more lumber than necessary. More importantly, it produced a cold spot in the wall during winter because the solid mass couldn’t be insulated. Known as “thermal bridging,” heat loss occurs when cold air is conducted through a solid material from the outside to the interior. In this case, from the sheathing, through the framing, to the interior drywall.

California corner

Exterior walls These days, a more common method of exterior corner construction uses two studs joined at right angles at the ends of the two plates, and a third nailed inside the two for backing. (Fig. 2) Often referred to as a “California corner,” this alternative method leaves room for insulation, so it’s more energy efficient. If additional backing is needed for corner boards, siding, or trim, a third stud can be added, leaving room for insulation. (Fig. 3) (For those who live in a seismic zone, check with your local building officials before you start. Seismic codes often require more mass in corners.) Interior walls The same two-stud configuration can be used on interior walls, but instead of a third stud for backing, some builders will use drywall clips—small right-angled tabs made from metal or plastic nailed onto the inside corner to take the place of a wood backer. As an alternative to clips, you can also attach backing made from 1x or 2x scrap material.

What you need to frame a corner stud wall:

Pair of sawhorses Circular or miter saw Tape measure Hammer Driver/drill 16d common nails 8d common nails or 3-in. construction screws—not drywall screws 2x4s or 2x6s Drywall clips or scrap lumber

Steps for Framing a Corner

Let’s assume that the walls are framed, in place, and only lack a corner. This arrangement works for an interior corner as well. Still, suppose you want to use less lumber. In that case, you can replace the third stud by nailing shorter 2x blocks or 1x material in the same location, or, as a third alternative, you can form the interior corner by nailing or screwing drywall clips every 12 inches or so to the inside edge of the inside stud.